Widebody Take 2 part 3

 In this update I finish up most of the metal work on the front fenders. I wanted to make sure both fenders were exactly the same, so before welding the driver's side fender seen below, I traced the top panel on some scrap poster board.

 I took the tracing, cut it out, and used it as a template for the passenger's side fender.

Once it was mocked up, I welded the panels in place.

...and temporarily shot the welds with some left over olive drab spray paint. They turned out pretty good. i still need to cut the rusty sections out of the bottoms, but that's for a different day.